How to cycle a fish tank: the short version
- Set up the tank fully: substrate, decor, filter, heater if you need one. Fill it with tap water treated with a dechlorinator.
- Run the filter around the clock. The bacteria live mostly in the filter media and on surfaces, and they need flowing, oxygenated water.
- Add an ammonia source: a pinch of fish food every day or two, or a measured dose of pure ammonia sold for fishless cycling.
- Test ammonia, nitrite and nitrate every two or three days and write the results down.
- Keep feeding the ammonia source as the readings change. Ammonia falls first, nitrite rises and then falls, nitrate builds.
- When ammonia and nitrite both read zero within about 24 hours of adding ammonia, do a large water change to bring nitrate down.
- Add a few fish at a time, not the whole stocking list at once.
Each stage, and the usual reasons a cycle seems to stall, are covered below.
Tankleaf puts ammonia, nitrite, nitrate, pH and KH on one entry screen and draws a chart for each, so you can watch the ammonia fall and the nitrite peak pass during a cycle. Get it on Google Play
The nitrogen cycle in an aquarium
Fish give off ammonia through their gills and in their waste, and uneaten food and dead plant matter release more as they break down. In a closed tank it has nowhere to go. Two groups of bacteria deal with it:
| Stage | What happens | What your test shows |
|---|---|---|
| 1. Ammonia | Waste and food break down into ammonia (NH₃/NH₄⁺) | Ammonia rises; nitrite and nitrate near zero |
| 2. Nitrite | The first bacteria turn ammonia into nitrite (NO₂⁻) | Ammonia starts to fall; nitrite climbs |
| 3. Nitrate | A second group turns nitrite into nitrate (NO₃⁻) | Nitrite falls; nitrate builds up |
| Cycled | Both groups keep up with the ammonia you add | Ammonia and nitrite at zero; nitrate present |
Nitrate is much less harmful than ammonia or nitrite, but it keeps accumulating. Regular water changes and plants are what remove it, which is why a cycled tank still needs maintenance.
Nitrite (NO₂) and nitrate (NO₃) differ by one letter on a test card, and mixing them up is a common reason people think a cycle is finished when it is not. Write the full name next to each result.
Fishless cycle vs fish-in cycle
In a fishless cycle you supply the ammonia yourself, so you can push the levels as high as the bacteria need without any animal in the water. In a fish-in cycle a few hardy fish provide the ammonia, and you change water often to keep ammonia and nitrite down while the bacteria grow.
| Fishless cycle | Fish-in cycle | |
|---|---|---|
| Ammonia source | Fish food or bottled ammonia | The fish |
| Risk to animals | None during the cycle | Fish are exposed to ammonia and nitrite |
| Water changes during the cycle | Few, unless levels go off the chart | Frequent, sometimes daily |
| Testing | Every two or three days | Daily is common |
Welfare bodies such as the RSPCA advise having the tank set up and the filter matured before fish go in. If you already have fish in an uncycled tank, test daily and follow the advice of an aquarium shop or vet you trust.
Ways to add ammonia
Fish food
A small pinch every day or two works and needs nothing extra. It is slow and hard to measure, and leftover food can cloud the water. Remove food that grows mould.
Bottled ammonia
Pure ammonia without surfactants or perfume gives a measurable dose. Follow the dosing instructions on the product you buy, as strengths differ, and test the next day to see what reading your dose produces in your tank.
Seeding from an established tank
A used filter sponge, some media or gravel from a healthy tank carries bacteria with it and can shorten the cycle a lot. Only take it from a tank you know is free of disease.
Bottled bacteria
Bacteria starters can help, but results vary. Keep testing as if you had not used one, and trust the readings rather than the label.
How to cycle a fish tank with plants
Live plants take up ammonia and nitrate directly, so a heavily planted tank may show lower readings throughout and sometimes skips an obvious nitrite peak. That can hide whether the bacteria are established. Keep dosing the ammonia source and look for the same end point: ammonia and nitrite at zero a day after dosing.
Fast-growing stem and floating plants help most. Slow plants like mosses and ferns on wood make little difference to the numbers.
Why a cycle seems stuck
- Nitrite will not drop. The second group of bacteria grows more slowly. Very high nitrite can hold them back; a partial water change to bring it down often gets things moving.
- Nothing happens for weeks. Check that the filter runs all the time, the water was dechlorinated, and the ammonia source is actually reaching the water.
- pH has dropped. The cycle uses up carbonate hardness (KH) and pH can fall with it. Testing pH and KH alongside ammonia shows when this is happening; a water change usually brings both back up.
- Cold water. Bacteria grow more slowly at low temperatures. Keep the tank at the temperature you plan to run it at.
- Filter cleaned in tap water. Chlorinated water can kill the bacteria. Rinse media only in tank water.
After the cycle: adding fish
The bacteria grow to match the ammonia they receive. A tank cycled on a small dose cannot handle a full load of fish overnight. Add a few fish, test ammonia and nitrite over the next week, and add more once the readings stay at zero.
Check the needs of each species you plan to keep, including temperature, pH and hardness, with the breeder, the shop or a species guide. Water that suits one fish may not suit another.
Keep your cycle readings in one place
Tankleaf logs each test on one screen and shows your last value next to every box, so a rising or falling trend is easy to spot from one test to the next.
Get it on Google PlayiPhone version coming soon
More guides
- How to Test Aquarium Water: Kits, Steps and What to TestHow to test aquarium water: test strips vs liquid kits, step-by-step testing for ammonia, nitrite, nitrate and pH, how often to test, and how to read results over time.
- How Often to Change Aquarium Water, and How MuchHow often to change aquarium water and how much to take out: a common starting point, what changes it, the nitrate math, and how to set a schedule for your tank.
- High Nitrates in Aquarium Water: Causes and What to DoHigh nitrates in your aquarium? Check the reading, find the cause (feeding, stocking, tap water, filter), bring it down gradually with water changes, and keep it there.
- Aquarium Maintenance Schedule: Daily, Weekly and Monthly ChecklistAn aquarium maintenance schedule you can copy: daily checks, weekly water changes and tests, monthly filter care, and occasional jobs, with tips on keeping it going.
Published by Zoranta, the developer of Tankleaf.